This shows you the differences between two versions of the page.
Next revision | Previous revision Last revision Both sides next revision | ||
projects:accessories:chg500:index [2017-01-16 15:54] macke created |
projects:accessories:chg500:index [2017-01-16 16:24] macke |
||
---|---|---|---|
Line 1: | Line 1: | ||
====== Overview and specification ====== | ====== Overview and specification ====== | ||
+ | External 1-cell 500mA li-po charger with micro-USB connector. For full specification please see the [[https:// | ||
====== Hardware ====== | ====== Hardware ====== | ||
- | {{ : | + | Revision A {{ : |
- | ====== Chaining ====== | + | Revision A layout seen from the top |
+ | {{: | ||
+ | ====== Chaining ====== | ||
+ | Using the P2 connector it's possible to chain multiple chargers together and only power one. This requires soldering. Below is a picture of one possible setup. Don't forget to check the rating of the connectors and make sure you use a power supply that can supply at least 500mA per charger. | ||
+ | <WRAP group> | ||
+ | <WRAP half column> | ||
+ | {{: | ||
+ | </ | ||
+ | <WRAP half column> | ||
+ | {{: | ||
+ | </ | ||
+ | </ | ||