projects:bolt:index
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
projects:bolt:index [2019-10-03 14:58] tobias [Current firmware status notes (2019-10)] |
projects:bolt:index [2019-10-08 14:12] tobias [Example setup] |
||
|---|---|---|---|
| Line 48: | Line 48: | ||
| * If higher then 8A is wanted only connect the signal wires from the ESC connectors to the ESC. Preferably still power the Bolt control board via the battery connector so the battery voltage can be monitored. | * If higher then 8A is wanted only connect the signal wires from the ESC connectors to the ESC. Preferably still power the Bolt control board via the battery connector so the battery voltage can be monitored. | ||
| + | ===== Example setup ===== | ||
| + | {{ : | ||
| ===== Configuration ===== | ===== Configuration ===== | ||
| The Crazyflie firmware will automatically detect that it is running on a Bolt and activate the right modules. However some of the configurations still has to be done during compile time and making them run time configurable is currently work in progress. | The Crazyflie firmware will automatically detect that it is running on a Bolt and activate the right modules. However some of the configurations still has to be done during compile time and making them run time configurable is currently work in progress. | ||
projects/bolt/index.txt · Last modified: 2019-12-09 15:17 by tobias
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
