Differences

This shows you the differences between two versions of the page.

--- projects:crazyflie2:expansionboards:aideck [2020-02-11 13:59]
tobias
+++ projects:crazyflie2:expansionboards:aideck [2020-02-12 11:53]
tobias [JTAG Debugging]
@@ Line 24: / Line 24: @@
 ===== JTAG Debugging =====
-There are two Cortex-M 10pin JTAG interfaces on the AI-deck so that both the GAP8 and the ESP32 can be programmed and debugged easily. To not build too much on the hight they are mounted on the edge of the PCB. The GAP8 JTAG is located to the left and the ESP32 JTAG to the right when viewing the board from top. Note that pin-1 is located to the left, marked with a 1 on the bottom side of the board.
+There are two Cortex-M 10pin (2x5, 1.27mm pitch) JTAG interfaces on the AI-deck so that both the GAP8 and the ESP32 can be programmed and debugged easily. To not build too much on the height they are mounted on the edge of the PCB. The GAP8 JTAG is located to the left and the ESP32 JTAG to the right when viewing the board from top. Note that pin-1 is located to the left, marked with a 1 on the bottom side of the board.
+The GAP8 SDK has recently added support for OpenOCD and thus many debuggers with a ftdi interface should be usable. We have tested JLink and Olimex ARM-USB-TINY-H with success. The STLink v2 will not work as it can only debug Cortex cores.
+Use a 2x5 pin 1.27mm (0.05") flat cable together with our [[https://www.bitcraze.io/debug-adapter-kit|debug adapter]] or e.g. adapter such as the [[https://www.olimex.com/Products/ARM/JTAG/ARM-JTAG-20-10|Olimex ARM-JTAG-20-10]], is needed to connect the debugger and the AI-deck.

Bitcraze Wiki

User Tools

Site Tools

Differences

Page Tools