Differences

This shows you the differences between two versions of the page.

--- projects:crazyflie:userguide:troubleshooting [2013-06-05 10:33]
tobias [I broke on of the PCB arms. Is it repairable?]
+++ projects:crazyflie:userguide:troubleshooting [2014-10-10 21:34]
chad [When I start the Crazyflie the red LED blinks 5 times and I can't fly it?] Sentence structure.
@@ Line 9: / Line 9: @@
 ==== When I start the Crazyflie the red LED blinks 5 times and I can't fly it? ====
 {{:projects:crazyflie:userguide:cf-client_console.png?direct |}}
-During the start-up all the mounted sensors run a self test. If either of these test fail it will cause the 5 red blinks. It is possible to see exactly what failed by connecting to the Crazyflie with the cf-client and open up the console tab.
+During the start-up all the mounted sensors run a self test. If any of these tests fail, the failure will cause the red LED to flash 5 times. It is possible to see exactly what failed by connecting to the Crazyflie with the cf-client and open up the console tab.
 The picture shows the console tab with no errors but when you have an error it might say e.g //MPU6050: Self test acc Y [FAIL]. low: 0.300000, high: 0.949999, measured: 0.0.// This example means that the accelerometer Y axis didn't pass the self test and is probably defective. It is possible to get 5 blink error also if the Crazyflie is moved to much during the self test, so try putting it on a sable surface before you power it on.
@@ Line 62: / Line 62: @@
 Try the following steps:
   - Power off the Crazyflie
-  - Un-plut and insert the Crazyradio again
+  - Un-plug and insert the Crazyradio again
   - Start the cfclient
   - Go to the menu //Crazyflie→Bootloader// and click //Initiate bootloader cold boot//

Bitcraze Wiki

User Tools

Site Tools

Differences

Page Tools