projects:crazyradio:programming
Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision Next revision Both sides next revision | ||
|
projects:crazyradio:programming [2012-09-17 14:53] arnaud created - Initial edit ... |
projects:crazyradio:programming [2015-01-07 11:58] macke |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | ====== Radio programming ====== | ||
| - | The Radio dongle can be programmed either via USB bootloader or via SPI. The USB bootloader does not require any hardware but is **not** currently (as of 2012-09) full-proff (if the flash procedure does not complete well the dongle will have to be reprogrammed via spi). It is adviced to program only released firmware via USB. | ||
| - | |||
| - | In Linux it might be required to launch the commands accessing the USB port as root (ie. with '' | ||
| - | |||
| - | ===== USB bootloader (command line instructions) ===== | ||
| - | |||
| - | First Crazyradio has to be reboted in USB bootloader mode. To do so insert the dongle in the pc, open a terminal window and launch the bootloader launcher: | ||
| - | |||
| - | < | ||
| - | cd pc_util/ | ||
| - | python launchBootloader.py | ||
| - | </ | ||
| - | |||
| - | After launching this tool the Crazyradio dongle should have disapeared and a new device named ... | ||
projects/crazyradio/programming.txt · Last modified: 2020-05-12 14:13 by kimberly
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
