projects:virtualmachine:jtag_debug
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Last revision Both sides next revision | ||
|
projects:virtualmachine:jtag_debug [2016-10-10 11:36] tobias |
projects:virtualmachine:jtag_debug [2016-10-10 11:41] tobias |
||
|---|---|---|---|
| Line 5: | Line 5: | ||
| ======= Crazyflie 2.0 ======= | ======= Crazyflie 2.0 ======= | ||
| - | The debug adapter is needed (or a cable could be made) to convert the ARM 20pin JTAG connector to the 6pin JST connector used on the Crazyflie 2.0. You will also need a JTAG/SWD debugger. The virtual machine is pre-configured to use the STLink v2 but can be set-up with any JTAG/SWD device that openOCD supports. | + | The [[projects: |
| The STM32F405 debug connector is located under the micro USB connector. | The STM32F405 debug connector is located under the micro USB connector. | ||
projects/virtualmachine/jtag_debug.txt · Last modified: 2021-06-02 11:21 by kimberly
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
